俗话说没有规矩不成方圆，哪怕在中空玻璃生产线上也有规矩需要遵守，首先原材料需要保证，再看密封胶和结构胶的采购预算，好的材料自然生产出好的成品。那么除此之前还需要注意哪些事项呢？
As the saying goes, there are rules to be observed even on the insulating glass production line. First, the raw materials need to be guaranteed, and then look at the procurement budget of sealant and structural adhesive. Good materials naturally produce good finished products. So what else should we pay attention to before that?

1.首先要检查中空玻璃加工设备水箱里的水充足，然后打开水泵，调整白色海绵辊上方的喷水管，保证海绵辊所有位置都能被冲洗到。然后用手将海绵辊上的杂质和脏物清洗干净，注意在冬天开启中空玻璃生产线时，一定不要先打开清洗传送，因为在没有被浸泡开的情况下打开传送，会导致海绵辊被撕坏。

1. First check that the water in the water tank of insulating glass processing equipment is sufficient, then turn on the water pump and adjust the water spray pipe above the white sponge roll to ensure that all positions of the sponge roll can be flushed. Then clean the impurities and dirt on the sponge roller by hand. Note that when opening the insulating glass production line in winter, do not open the cleaning transmission first, because opening the transmission without being soaked will cause the sponge roller to be torn.
2.然后打开清洗传送，将待加工的中空玻璃放在传送轮上，注意玻璃一定要放平稳，防止玻璃在传送过程中掉落伤到人。
2. Then open the cleaning conveyor, place the hollow glass to be processed on the conveyor wheel, and pay attention to the glass must be placed stably to prevent the glass from falling and hurting people during transmission.
3.铝隔条上涂抹的丁基胶要保证均匀，而且涂抹在整个铝条表面，防止漏胶，有毛刺现象。并且采用优良丁基胶保证铝条和玻璃结实的站合在一起。铝隔条涂完胶后禁止有粘上灰尘。
3. Butyl glue applied on the aluminum spacer strip shall be uniform and applied on the whole surface of the aluminum strip to prevent glue leakage and burr. And it adopts excellent butyl glue to ensure that the aluminum strip and glass stand together firmly. It is forbidden to stick dust on the aluminum spacer after coating.
4.双组份密封胶要涂抹牢固，表面保持平滑，尤其是拐角处要涂抹好，防止漏气，跑气现象。
4. The two-component sealant shall be applied firmly and the surface shall be smooth, especially at the corners to prevent air leakage and air escape.
以上中空玻璃加工设备使用注意事项在生产过程中一定要严格遵守。
The above precautions for the use of insulating glass processing equipment must be strictly observed in the production process.